How to check a user’s Safe Senders in Exchange 2010/2013

2017-12-07T11:50:20+00:00 April 1st, 2015|Exchange|

Following on from the blocked senders blog http://support.risualblogs.com/blog/2015/04/01/how-to-check-a-users-blocked-senders-in-exchange-20102013/ , I thought I’d let you know the commands to add a safe sender , they’re very similar to adding a blocked sender.

From the EMS run the below commands:

To Find out a user’s Safe senders

Get-MailboxJunkEmailConfiguration -Identity “ChangeName” | FL TrustedSendersandDomains

This will return the below

To Add a user to Safe senders

Set-MailboxJunkEmailConfiguration -Identity “ChangeName” –TrustedSendersandDomains @{Add=”test2@test.com”}

If you run the Get-MailboxJunkEmailConfiguration -Identity “ChangeName” | FL TrustedSendersandDomains , you will see the address has been added.

To Remove a user from trusted senders

Set-MailboxJunkEmailConfiguration -Identity “ChangeName” –TrustedSendersandDomains @{Remove=”test2@test.com”}

Those are the commands to add, remove and check blocked senders!